MT29F1G08ABADAH4 – NAND Flash Memory

MT29F1G08ABADAH4 Datasheet PDF learn more.

Part number : MT29F1G08ABADAH4

Functions : This is a kind of semiconductor, NAND Flash Memory.

Pin arrangement :

Package information :

Manufacturer : Micron Technology

Image :

MT29F1G08ABADAH4 Datasheet PDF

The texts in the PDF file :

Micron Confidential and Proprietary Preliminary‡ 1Gb x8, x16: NAND Flash Memory




• Open NAND Flash Interface (ONFI) 1.0-compliant1 • Single-level cell (SLC) technology • Organization – Page size x8: 2112 bytes (2048 + 64 bytes) – Page size x16: 1056 words (1024 + 32 words) – Block size: 64 pages (128K + 4K bytes) – Device size: 1Gb: 1024 blocks • Asynchronous I/O performance – tRC/tWC: 20ns (3.3V), 25ns (1.8V) • Array performance – Read page: 25µs3 – Program page: 200µs (TYP, 3.3V and 1.8V)3 – Erase block: 700µs (TYP) • Command set: ONFI NAND Flash Protocol • Advanced command set – Program page cache mode5 – Read page cache mode5 – One-time programmable (OTP) mode – Read unique ID – Internal data move • Operation status byte provides software method for detecting – Operation completion – Pass/fail condition – Write-protect status • Internal data move operations supported within the device from which data is read • Ready/busy# (R/B#) signal provides a hardware method for detecting operation completion • WP# signal: write protect entire device • First block (block address 00h) is valid when shipped from factory with ECC. For minimum required ECC, see Error Management. • Block 0 requires 1-bit ECC if PROGRAM/ERASE cycles are less than 1000 • RESET (FFh) required as first command after poweron • Alternate method of device initialization (Nand_Init) after power up4 (contact factory) • Quality and reliability – Data retention: 10 years • Operating Voltage Range – VCC: 2.7–3.6V – VCC: 1.7–1.95V • Operating temperature: – Commercial: 0°C to +70°C – Extended (ET): –40ºC to +85ºC • Package – 48-pin TSOP type 1, CPL2 – 63-ball VFBGA Notes: 1. The ONFI 1.0 specification is available at 2. CPL = Center parting line. 3. See El [ … ]


This entry was posted in Uncategorized. Bookmark the permalink.