CNH20R106M-TM – High capacitance 3-terminal capacitors

CNH20R106M-TM Information is available here.

Part Number : CNH20R106M-TM

Function : This is a kind of semiconductor, High capacitance 3-terminal capacitors.

Pinouts :

Package :

Manufacturer : MARUWA

Image :

CNH20R106M-TM データシート

Some text files in PDF file :

MARUWA GENERAL CATALOG PERFORMANCE AND TEST METHOD EMI FILTERS Item Dissipation Factor Withstanding voltage Insulation resistance Adhesion strength of termination Vibration resistance Resistance to soldering heat Visual Capacitance Dissipation factor Visual Capacitance Dissipation factor Insulation resistance Withstanding voltage Solderability Temperature cycling Humidity load test Life test at high temperature load Visual Capacitance Dissipation factor Insulation resistance Withstanding voltage Visual Capacitance Dissipation factor Insulation resistance Visual Capacitance Dissipation factor Insulation resistance Flexion Visual Capacitance CG, UJ Performance 2.5% or less ‫ء‬1) R Testing method and conditions F (In accordance with JIS C5101-1) 5% or less ‫ء‬1) CG : 1MHz UJ, R, F : 1kHz Measurement voltage : 0.5~2Vrms No insulation breakdown and no failure. No less than 10,000M⍀ or 500M⍀ • ␮F, whichever is smaller. Application time is 1~5seconds. CG, UJ : 300% of rated voltage R, F : 250% of rated voltage Rated voltage is applied for 1 minute. Chip 5N Substrate No peeling-off or exfoliation shall be manifest or recognizable in its incipient stages. Solder a specimen on the testing jig shown on the left and apply a force of 5N (0.51kgf) in the direction indicated by arrow. No remarkable damage Within specified tolerance Initial standard values must be satisfied. No remarkable damage No more than ȗ2.5% or ȗ0.25pF, whichever is larger. Within ȗ7.5% Initial standard values be satisfied. Initial standard values be satisfied. No damage or insulation breakdown. Within ȗ20% Vibration frequency : 10~55Hz Full amplitude : 1.5mm, 10~55~10Hz 1min. XYZ direction 2hrs for each total 6hrs. Solder : H60A or H63A (JIS Z 3282) Soldering temperature : 270ȗ5°C Immersion time : 10ȗ1sec. Preheat : 80~100°C (1~2min.) and 170~200°C (1~min.) Immersion into solder should be carried out continuously af [ … ]

CNH20R106M-TM PDF File



This entry was posted in Uncategorized. Bookmark the permalink.